TANDBERG 7000 MXP User Manual download pdf (Page 2)

TANDBERG 7000 MXP

CAUTION!

Avoid displaying the same images continuously over a long period

of time on the monitors.

Displaying the same images such as still images for a long time may cause after-image

lagging. This may occur in the following two cases:

1. After image lagging due to remaining electrical load

When image patterns with very high peak luminance are displayed for more than 1 minute,

after-image lagging may occur due to the remaining electric load. The after-images remaining

on the screen will disappear when moving images are displayed. The time for the after-images

to disappear depends on the luminance of the still images and the time they had been

displayed.

2. After-image lagging due to sticking

When images of the same pattern are displayed continuously for several hours or displayed

for a short period of time every day, after-images may remain on the screen due to the

sticking of the fluorescent materials. In this case, these images may decrease if moving

images are displayed after them, but basically they will not disappear.

Solving after-image lagging problems

If you have got after-image lagging on your monitors, you can reduce the problem to an

acceptable level by displaying a white image on the monitors for a few hours. This can be

accomplished by focusing the camera towards a white paper and setting maximum

brightness. See the ‘User Manual’ for details.

NOTE: Warranty may be invalidated if the precautions listed above are not followed.

1 2 3 4 5 6 7 ... 331 332

No comments

TANDBERG 7000 MXP User Manual Page 2